Results 1 to 1 of 1

Thread: Hex planes GD&T

  1. 06-24-2015, 03:43 PM #1
    Happyfeet63
    Guest

    Hex planes GD&T

    In the attached PDF, the small hex sides need to be parallel and aligned angularly with respect to the large hex to within +- 0.005. The question is does the angular FCF tolerance need to be in degrees? Secondly, are the tolerances and nomenclatures reasonable and, if so, correct and measurable?
    Attached Files Attached Files
    Reply With Quote Reply With Quote
« What is the correct way to tolerance this True Position callout on a bolt hole circle | GD&T profile tolerance help »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules