Results 1 to 4 of 4

Thread: Need help on how to PROPERLY inspect this dimension

  1. 04-19-2016, 12:03 PM #1
    jozf
    jozf is offline
    Associate Engineer
    Join Date
    Apr 2016
    Posts
    2

    Need help on how to PROPERLY inspect this dimension

    The .875 Radius is in print, but the location from the center of the square to the .875 R is out of tolerance by a couple thousandths. Is this calling out location or radius? And how would you check it?
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. 04-19-2016, 02:27 PM #2
    Kelly_Bramble
    Kelly_Bramble is offline
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    Looks antique... What standard is the engineering drawing specified to?
    Tell me and I forget. Teach me and I remember. Involve me and I learn.
    Reply With Quote Reply With Quote
  3. 04-19-2016, 02:31 PM #3
    jozf
    jozf is offline
    Associate Engineer
    Join Date
    Apr 2016
    Posts
    2
    70s haha... MIL-STD-100
    Reply With Quote Reply With Quote
  4. 04-19-2016, 07:42 PM #4
    Kelly_Bramble
    Kelly_Bramble is offline
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    Looks like the top radius feature center point is located relative to the center of the square feature and built in size to R .875 +0, -.010
    Tell me and I forget. Teach me and I remember. Involve me and I learn.
    Reply With Quote Reply With Quote
« Position of Hole where Primary Datum is Paralell to Hole Axis | Callout for threaded hole to be tapped straight »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules