Results 1 to 8 of 8

Thread: Reading annotations, radius

  1. #1
    Associate Engineer
    Join Date
    Jun 2017
    Posts
    5

    Confused Reading annotations, radius

    Hi!

    I am reading these blueprints of a bread toaster and I just can not figure out how to dimension a fully defined sketch out of this.

    My main issue of understanding are these radius annotations. What is the difference between R60 and R40, appart from the obvious radius difference.

    May someone shed some light on this matter? I am out of ideas.


    (Bottom view and zoom in)

    (Iso-view of bread toaster)
    Attached Images Attached Images
    Last edited by jhg17004; 06-13-2017 at 06:55 AM.

  2. #2
    Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    It's a complex curve composing of several radius... where each radius starts and ends is missing data.

  3. #3
    Associate Engineer
    Join Date
    Jun 2017
    Posts
    5
    I was suspecting this as well but didnt dare to assume it was missing data.

    This concerns me. When I attempt to sketch with these dimensions I can not achieve a similar shape.
    I will bring this to my teacher and see whats going on.

  4. #4
    Technical Fellow jboggs's Avatar
    Join Date
    Mar 2011
    Location
    Myrtle Beach, SC
    Posts
    908
    You can assume the curves are tangential, else the joint would be a sharp corner. That will help you locate the centers. The center of the larger radius, the center of the smaller radius, and the tangent point will all lie on the same line.

  5. #5
    Associate Engineer
    Join Date
    Jun 2017
    Posts
    5
    Is that why one of the radius arrows extend all the way to the centerline?

    Still though, my biggest concern is R20, how does it connect to the others. If its center originates from the centerline, is will look like this. Please im going insane, I feel like im missing out on something fundamental.

    Look at this mess!
    Attached Images Attached Images
    Last edited by jhg17004; 06-15-2017 at 03:02 AM.

  6. #6
    Associate Engineer
    Join Date
    Jun 2017
    Posts
    5
    I dont even know whats going on anymore, but this is possibly correct.

    I will have to ponder about this...

    Attached Images Attached Images
    • File Type: png 4.png (11.9 KB, 16 views)

  7. #7
    Technical Fellow jboggs's Avatar
    Join Date
    Mar 2011
    Location
    Myrtle Beach, SC
    Posts
    908
    These are all good questions for a student to ask. We are limited in how much "help" we can give on homework. You are on the right track. In fact, your last diagram appears to be correct, but you are unsure why. Examine at your last diagram very carefully while you carefully re-read my statement from above: "The center of the larger radius, the center of the smaller radius, and the tangent point will all lie on the same line." I did not say the centers of the two radii would be at the same point. (The tangent point is the point where the two arcs meet.)

  8. #8
    Associate Engineer
    Join Date
    Jun 2017
    Posts
    5
    Thank you for the attention, also for the great compliment from jboggs.

    I believe to have solved it and I will post some results and conclusions next thing in the morning.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •