Results 1 to 2 of 2

Thread: Determining max bending plane for a shaft with multiple belt loads

  1. #1
    Associate Engineer
    Join Date
    Nov 2017
    Posts
    1

    Determining max bending plane for a shaft with multiple belt loads

    I've a situation where a shaft is driven by a timing belt, which then drives a flat belt. The drive belt tension vector is about 40 degrees from the driven belt. The drive and driven belts are not close enough together to be considered co-planar. I'm interested in bending at a bearing shoulder.

    There should be a plane where the moments from the belt loads create a maximum. I'd thought to simply make function of Mcos(a-b), where a was variable angle, and b was the orientation of the belt load moment relative to a datum, and combine that with a similar function for M2. The moment diagrams have to be generated separately.

    Is this reasonable? Is there a good example somewhere? All examples I found were perpendicular loads that could be combined with Pythagorean theorem.

    thx.

  2. #2
    Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    I'm sure that the load is simply a single vector at some angle relative to the shaft and bearing shoulder.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •