Reply With QuoteSee ASME Y14.5-2009, sub paragraphs 1.4 a, c and d.
When the position of a hole is established using a geometric tolerance, is the title block tolerance automatically applied to the diameter, or is it required to repeat the hole diameter tolerance even if the tolerance is the same as listed in the title block? Is it considered redundant to repeat the title block tolerance for diameter on each hole using a geometric positional tolerance?
If someone could point me to a particular section in Y14.5-2009 where the specific requirements and hierarchy of title block tolerances vs geometric tolerances is described, that would be appreciated.
See ASME Y14.5-2009, sub paragraphs 1.4 a, c and d.
Tell me and I forget. Teach me and I remember. Involve me and I learn.
If the sheet tolerance applies to the diameter of the hole, I do not repeat the tolerance.
Yes, in general there should not be any redundancy in tolerance or dimension specifications. Can cause confusion and even conflicting requirements.Originally Posted by jasonamurawski
Tell me and I forget. Teach me and I remember. Involve me and I learn.
Posting Permissions