Results 1 to 6 of 6

Thread: No. of Holes

  1. #1

    No. of Holes

    I am design valve disc how to calculate the no. of bolts required to for valve seal Clamp in it's position.
    Capture.PNG

  2. #2
    Lead Engineer
    Join Date
    Aug 2013
    Location
    Houston TX USA
    Posts
    421
    Does this container pressurized and if so to what pressure; and what type of cover seal are you using?

  3. #3
    Yes, it's pressurized about 16 bar and i am using rubber seal.

  4. #4
    Lead Engineer
    Join Date
    Aug 2013
    Location
    Houston TX USA
    Posts
    421
    Is it a flat gasket or O-ring type seal? Have you done the design pressure load and stress calculations for the cover plate?

  5. #5
    Principle Engineer
    Join Date
    May 2015
    Posts
    216
    Multiply the pressure times the area inside the gasket to get the force trying to push the cover off the valve. The total clamp load of the bolts should be several times this value. How many times depends upon engineering judgement.

    So make the clamp load ten times the lifting force and see how it looks.

  6. #6
    There is a page on the website related to this exact subject:
    https://www.engineersedge.com/genera...ompression.htm

    Another consideration you can make for bolt circles on sealing flanges is spacing of the bolt frustum.
    Long story short: each bolt makes a cone shaped stress region below its head. If you make those cones overlap then you end up with a high performance flange that resists leaking. May be overkill for your application since it's just 16 bar.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •