I am trying to get better at GD&T. I created two parts and did drawings for them. Can someone please help me and do a markup or give me some pointers on things I did wrong? I would love it if someone would check the individual parts and do a tolerance stack up to see at worst case if there will be any interference.
I just used my best judgement for design intent since I don't actually have an application for these parts.
Any help is greatly appreciated.
To get better with dimensioning and tolerancing, I would suggest that you seek out some training and/or ask an available work mentor to assist.Originally Posted by mtpinnc
This is your first post on Engineers Edge (you've contributed nothing to others), you're not a previous student or customer, and you're asking for a design, drafting check as well an tolerance analysis completed for YOU.
Love to help people learn, move forward and be better designers and engineers but your request is a bit much..
In the future, I suggest you first contribute to this or any forum before expecting so much. Additionally, I suggest you at least try (tolerance analysis) before asking.
Good luck in your endeavors.
Closing the thread...
Tell me and I forget. Teach me and I remember. Involve me and I learn.
Posting Permissions
