Reply With QuoteSand cast, You sure? You would need approximately .050" (1.3mm) machining allowance.
I suspect this is more of a die cast part.
My question: how to manufacture a waterfall faucet?
> I use PTC Creo for designing. Designing is easy.
> During sand casting, the product is casted.
> But the problem lies in machining. How to machine it?
Any suggestions? Am I following the wrong procedure in making this faucet?
Sand cast, You sure? You would need approximately .050" (1.3mm) machining allowance.
I suspect this is more of a die cast part.
I don't understand your question - "How to machine it?".
Are you saying you don't understand the machining steps involved to create the various parts? If that is the case then get advice from a machinist or a machine shop. No one here could tell you all the machining steps involved for each part from just a photograph of a completed assembly. Even a machinist would have to see drawings of each piece. Not near enough detail.
Posting Permissions