Results 1 to 3 of 3

Thread: Arrow location on Profile

  1. #1
    Associate Engineer
    Join Date
    Jul 2021
    Posts
    2

    Arrow location on Profile

    Does it matter which side of the profile line the arrow is on when considering Unequally Disposed Profile? Where is this documented in Y14.100? In other words, if I put my arrow on the top side then the Unequally Disposed Profile would be above the nominal or adding material. If I point my arrow from below the line, does that mean the Unequally Disposed Profile would be the nominal or subtracting material?
    Thanks for any help.

  2. #2
    Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    No, it does not matter. Depending on the standard you are utilizing either the circle U and the 0.0 to # offset tolerance to indicate inside or outside (See ASME Y14.5-2018) or an offset phantom line may be utilized to clearly indicate the unilateral tolerance - see ISO 1101 any year or ASME Y14.5-2009.

  3. #3
    Associate Engineer
    Join Date
    Jul 2021
    Posts
    2
    It is my understanding that the if a call out is profile .020 U .015 this would mean the profile should be +.015 of material to -.005 of material from the nominal, whether a pocket or boss. It would then be my understanding that on a pocket with the nominal being 1.000 x 3.000, it could measure from .970 x 2.970 to 1.010 x 3.010 likewise a boss it would measure 1.030 x 3.030 or .990 x 2.990.

    Am I understanding this correctly, or did I miss something in the standard where it explains this better.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •