Results 1 to 3 of 3

Thread: Runout on partial diameter

  1. 08-09-2021, 05:35 PM #1
    uofmguy2017
    uofmguy2017 is offline
    Associate Engineer
    Join Date
    Jul 2021
    Posts
    6

    Runout on partial diameter

    Hi guys, Is it okay to apply runout for a non-diametrical feature as shown? (attached)
    ASME 14.5Y 2009
    (the dims and tol are arbitrary, I am more interested in if it's technically correct, possible and/or recommended to use runout in a situation like this)

    Thanks for any guidance that you can provide!
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. 08-09-2021, 06:03 PM #2
    Kelly_Bramble
    Kelly_Bramble is offline
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    Yes you can however I would use the "Between" symbol to indicate where the circular runnout applies.
    Tell me and I forget. Teach me and I remember. Involve me and I learn.
    Reply With Quote Reply With Quote
  3. 08-09-2021, 06:09 PM #3
    uofmguy2017
    uofmguy2017 is offline
    Associate Engineer
    Join Date
    Jul 2021
    Posts
    6
    Perfect Kelly, thanks!
    Reply With Quote Reply With Quote
« Profile with MMB modifier -question | Arrow location on Profile »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules