Results 1 to 3 of 3

Thread: Tolerance zone with position & angle

  1. #1
    Associate Engineer
    Join Date
    Jul 2021
    Posts
    6

    Tolerance zone with position & angle

    Question for you all. I am not sure if the attached is controlling the orientation and location of the two notches at 60deg.

    Does the 2X notch position dim & FCF control both the center axes orientations and locations of the notches with this setup?

    I appreciate any help I can get on this!
    (per ASME 14.5Y 2009)
    Attached Images Attached Images

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    Yes, the 2x position tolerance as specified does control the orientation and location of the center PLANE of the notch features relative to the DRF A|B|C.

    I would have actually put two separate 60 deg basic dimensions (one for each notch) but that's just personal preference.
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

  3. #3
    Associate Engineer
    Join Date
    Jul 2021
    Posts
    6
    Quote Originally Posted by Kelly Bramble View Post
    Yes, the 2x position tolerance as specified does control the orientation and location of the center PLANE of the notch features relative to the DRF A|B|C.

    I would have actually put two separate 60 deg basic dimensions (one for each notch) but that's just personal preference.
    Perfect! Thank you!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •