Results 1 to 4 of 4

Thread: Flatness and surface finish spec

  1. #1
    Associate Engineer
    Join Date
    Mar 2023
    Posts
    6

    :bash: Flatness and surface finish spec

    Image attachment failed - reattach

    In Detail A view, Im installing a hyd. motor in a welded plate and the install guide calls for flatness but what does "S" mean in regards to the tolerance.

    Same for the surface finish. Im not sure what "V" means for the average roughness.

    Thanks
    Last edited by Kelly_Bramble; 03-20-2023 at 11:07 AM.

  2. #2

  3. #3
    Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    My guess... is that somewhere on the engineering drawing there is a note, table or reference document that defines "S" as well as V, U and M.

  4. #4
    Associate Engineer
    Join Date
    Mar 2023
    Posts
    6
    Thanks, I did find it in a separate guide.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •