Results 1 to 2 of 2

Thread: Heat Treat callout

  1. 04-27-2023, 08:39 AM #1
    Mhilgers
    Mhilgers is offline
    Join Date
    Apr 2023
    Posts
    1

    surprise2 Heat Treat callout

    I want to show area to test for hardness on small diameter shaft. What is common practice.
    Reply With Quote Reply With Quote
  2. 04-27-2023, 08:49 AM #2
    Kelly_Bramble
    Kelly_Bramble is offline
    Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    On your engineering drawing or reference document use a chain line with a leader pointing to it referencing a note "test here" or equivalent.

    You can put dimensions on the chain line area.
    Reply With Quote Reply With Quote
« Funny profile tolerancing with (U) must match the adjacent recess diameter tolerance! | Profile of a line on a drawing? »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules