Membership Services

Re: Re: ASME Section VIII Appendix Y (flange) calcs

[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Jaswinder S Bansal (203.200.72.194) on March 10, 2003 at 03:01:47:

In Reply to: Re: ASME Section VIII Appendix Y (flange) calcs posted by Juárez Pérez Luis on December 17, 2002 at 16:59:54:

: : I am attempting to perform Appendix Y stress calculations on a custom flange design for a test article. Two of the stress formulas, Eq's. 15a (tangential flange stress at ID) and 16a (longitudinal hub stress) refer to a variable (theta sub B = slope of flange face at inside diameter, rad). No other references to this variable or how it is obtained can be found in Appendix Y or in Appendix 2. Any idea where this comes from? Any help would be greatly appreciated.

Follow Ups:

Post a Followup

Subject: Re: Re: Re: ASME Section VIII Appendix Y (flange) calcs

Comments:
: : : I am attempting to perform Appendix Y stress calculations on a custom flange design for a test article. Two of the stress formulas, Eq's. 15a (tangential flange stress at ID) and 16a (longitudinal hub stress) refer to a variable (theta sub B = slope of flange face at inside diameter, rad). No other references to this variable or how it is obtained can be found in Appendix Y or in Appendix 2. Any idea where this comes from? Any help would be greatly appreciated.

[ Home ][ Forum Archive ] [ Active Engineering Forum ]