Membership Services

True Position Gage

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Alex D. on January 25, 2002 at 20:04:09:

When designing a true position go/no go fixture for a four bolt hole circle from a center point and all locations located at their absolute nominal, would I just reduce the diameter of the location pis by the allowable true position circular area?
Example; Hole dia.= .472-.476
True pos.= .008(M) True pos. circular area limits = +/-.0028
Reduce "ALL" pins. .472(L)-2(.0028) = .4664

Follow Ups

Re: True Position Gage Don Laughery 20:44:52 4/24/2002 ( 0)
Re: True Position Gage Randy 18:35:00 3/02/2002 ( 0)

< "> Subject: Re: True Position Gage

Comments: : When designing a true position go/no go fixture for a four bolt hole circle from a center point and all locations located at their absolute nominal, would I just reduce the diameter of the location pis by the allowable true position circular area? : Example; Hole dia.= .472-.476 : True pos.= .008(M) True pos. circular area limits = +/-.0028 : Reduce "ALL" pins. .472(L)-2(.0028) = .4664

[ Home ][ Forum Archive ] [ Active Engineering Forum ]