Membership Services

Re: Re: Gearbox Design

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Mark Donnelly on October 11, 2002 at 10:58:33:

In Reply to: Re: Gearbox Design posted bySerdar Yorulmaz on October 06, 2002 at 10:01:52:

Serdar,
i was wondering if you know the modulus of elasticity for the following materials are: (for the shafts)

15-5SS
4140HT
18CrNi10

The reason behind this is so i can determine deflection in the shaft, the deflection I have to have is a maximum deflection of 0.035mm. As well how would I calculate the diameter of my shaft, i found a rather large formula to calculate the shaft but i was wondering if there is an easier way to calculate the diameter.
Thanks in advance.

-Mark

Follow Ups

Subject: Re: Re: Re: Gearbox Design

Comments:: Serdar, : i was wondering if you know the modulus of elasticity for the following materials are: (for the shafts) : 15-5SS : 4140HT : 18CrNi10 : The reason behind this is so i can determine deflection in the shaft, the deflection I have to have is a maximum deflection of 0.035mm. As well how would I calculate the diameter of my shaft, i found a rather large formula to calculate the shaft but i was wondering if there is an easier way to calculate the diameter. : Thanks in advance. : -Mark

[ Home ][ Forum Archive ] [ Active Engineering Forum ]