Membership Services

Re: 3 phase testing

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">sachin shinde on October 18, 2002 at 02:56:41:

In Reply to: 3 phase testing posted byNigel Ottman on April 23, 2002 at 09:52:38:

: I'm looking for a quick and easy way to test a three phase safety switch. The switch monitors: hi/low voltage (easy to test), phase imbalance (tough), phase reversal (easy), and loss of phase. voltage is 420/480. any suggestions? Currently we used a step up transformer (hi voltage), switched two lines (phase reversal), tried to remove a phase.. thus lost power, and that was about all I could test for. I would like to set up some kind of a permanent test fixture as we use alot of these.

Follow Ups

Subject: Re: Re: 3 phase testing

Comments:: : I'm looking for a quick and easy way to test a three phase safety switch. The switch monitors: hi/low voltage (easy to test), phase imbalance (tough), phase reversal (easy), and loss of phase. voltage is 420/480. any suggestions? Currently we used a step up transformer (hi voltage), switched two lines (phase reversal), tried to remove a phase.. thus lost power, and that was about all I could test for. I would like to set up some kind of a permanent test fixture as we use alot of these.

[ Home ][ Forum Archive ] [ Active Engineering Forum ]