Membership Services

Re: Re: ASME Section VIII Appendix Y (flange) calcs

[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by John Andrews (209.113.165.94) on December 04, 2002 at 15:28:29:

In Reply to: Re: ASME Section VIII Appendix Y (flange) calcs posted by John Andrews on December 02, 2002 at 15:00:38:

Earlier I had replied to "just divide by the modulus of elasticity"...however, this is actually E*i not Ei. Look in Section Y-3 of Appendix Y to find the relation for E*i (which is just a factor that considers the flange thickness). Hope this helps.

John

Follow Ups:

Post a Followup

Subject: Re: Re: Re: ASME Section VIII Appendix Y (flange) calcs

Comments:
: Earlier I had replied to "just divide by the modulus of elasticity"...however, this is actually E*i not Ei. Look in Section Y-3 of Appendix Y to find the relation for E*i (which is just a factor that considers the flange thickness). Hope this helps. : John

[ Home ][ Forum Archive ] [ Active Engineering Forum ]