Membership Services

Re: Re: Hole Position to -A- only

[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Antonio Patino (4.22.37.4) on December 18, 2002 at 17:19:33:

In Reply to: Re: Hole Position to -A- only posted by Randy Kimball on December 11, 2002 at 19:23:44:

Maybe it is a concentricity, I have worked with several parts that the designer uses a True position as a concentricity requirment. If I remember correctly this is what I have seen:

TP/ dia .002 MMC / A MMC

Where A is the center on another hole to which the machined hole has to be aligned.

maybe similar to what you have, hope it helps..

Regards

Follow Ups:

Post a Followup

Subject: Re: Re: Re: Hole Position to -A- only

Comments:
: Maybe it is a concentricity, I have worked with several parts that the designer uses a True position as a concentricity requirment. If I remember correctly this is what I have seen: : TP/ dia .002 MMC / A MMC : Where A is the center on another hole to which the machined hole has to be aligned. : maybe similar to what you have, hope it helps.. : Regards

[ Home ][ Forum Archive ] [ Active Engineering Forum ]