Design of Tapers for Shafts

Design of Tapers for Shafts
	Post Reply		Forum

Posted by: Larry Wiley

03/03/2003, 21:35:44

Edit

I am looking for information for and/or direction to literature on recommendations for properly sizing of tapers on shafts and matching tapered holes in rotating machine components to insure tight joints that are subject to maintenance only after long term operations. Information desired is the tolerances of shaft taper versus the hole taper, heat treating recommendation for tapered steel shafts and rotating component tapered holes to insure long term joint intergrity.

Post Reply | Recommend | Alert

Rate

| Next |