Engineers Edge

[Home] [Design Resources] [Technology Store]

Concentricity Tolerance
Post Reply   Forum
Posted by: Ron A.

04/11/2003, 17:44:35

Edit
Is it correct (or practical) to put a Concentricity tolerance on a pitch diameter for a bolt circle?I saw this on a drawing, and it struck me funny, especially since there was no position tolerance on the bolt holes.How would it be measured?Thanks!








Post Reply | Recommend | Alert Rate View All   | Next |

Replies to this message

-----Re: Concentricity Tolerance John Paul Belanger 0 1467 bytes 04/12/2003, 09:25:13

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer