|
||||||||||||
|
||||||||||||
| WIRE CUT | |||
| Post Reply | Engineering Forum | ||
| Posted by: PAULSON_P17 ® 06/02/2009, 06:47:17 Author Profile eMail author Edit |
IS IT POSSIBLE TO WIRE CUT A COUNTER-SUNK HOLE WHOSE INCLUDED ANGLE IS 45 DEGREE THE MATERIAL THICKNESS IS ABOUT 20mm |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | Next | |
| Replies to this message |
| : WIRE CUT | |||
| : WIRE CUT -- PAULSON_P17 | Post Reply | Top of thread | Engineering Forum |
| Posted by: Kelly Bramble ® 06/02/2009, 08:38:31 Author Profile eMail author Edit |
There are technologies (machines) that can wire EDM that geometry, however one can definitely Ram EDM and create the geometry. Ram is also called "Plunge" and "Sinker" edm. See EDM Machining
|
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
