|
Design and Engineering Forum |
[Home] [Design Resources] [Technology Store] |
[Archive#1] [Archive #2] [Archive #3] [Calculators] |
|
Morse Taper specs | |||
Post Reply | Forum |
Posted by: Augusto ® 01/08/2004, 12:05:11 Author Profile Mail author Edit |
I need to fabricate an adapter to drive a morse taper drill bit in my regular chuck, please tell me the angle of the morse taper. Thanks
|
Post Reply | Recommend | Alert | Rate | View All | | Next | |
Replies to this message |
Re: Morse Taper specs | |||
Re: Morse Taper specs -- Augusto | Post Reply | Top of thread | Forum |
Posted by: morsetaper2 ® 01/08/2004, 20:57:24 Author Profile Mail author Edit |
A Morse taper (MT) is desribed by a taper per inch. The values for a morse taper are in the machinery's handbook. The rate of taper varies by the designation of the taper, MT1, MT2, MT3, MT4, & MT5. I don't have my machinery's handbook near so I can't give you numbers. There are other variations, for example there is a MT 4-1/2 on the ID of some early South Bend lathe spindles. Which MT are you looking for? Mark
|
Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer