|
Design and Engineering Forum |
[Home] [Design Resources] [Technology Store] |
[Archive#1] [Archive #2] [Archive #3] [Calculators] |
|
I Need Feedback - Assembly Mass Estimation Worksheet | |||
Post Reply | Forum |
Posted by: Administrator ® 02/26/2004, 08:48:03 Author Profile Mail author Edit |
Hello all, If you have a couple of minutes, please review the following resource page and reply to this thread with your comments and suggestions. /calculators/mass_estimate_worksheet.htm Thank you! |
Post Reply | Recommend | Alert | Rate | View All | | Next | |
Replies to this message |
Re: I Need Feedback - Assembly Mass Estimation Worksheet | |||
Re: I Need Feedback - Assembly Mass Estimation Worksheet -- Administrator | Post Reply | Top of thread | Forum |
Posted by: Cragyon ® 03/01/2004, 09:33:05 Author Profile Mail author Edit |
Well, I like it, however, you might set it up so that it prints onto a standard sheet and is readable. When I print it, it comes out on three standard sheets of paper all broke up. You might turn the display 90 degrees. Also, when I leave the sheet it does not remember my original inputs.
|
Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread |
Re: Feedback | |||
Re: I Need Feedback - Assembly Mass Estimation Worksheet -- Administrator | Post Reply | Top of thread | Forum |
Posted by: RandyKimball ® 02/26/2004, 20:03:22 Author Profile Mail author Edit |
Hi,
I like it. Do these paste and run in MS Excel? I could just find out but thought the question would be a natural question from the user group.
The worst suggestion of you lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them. |
Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread | | | |
Re: Feedback | |||
Re: Re: Feedback -- RandyKimball | Post Reply | Top of thread | Forum |
Posted by: Administrator ® 02/29/2004, 20:06:45 Author Profile Mail author Edit |
Currently, the data does not. I believe this tool needs some work so that users can import from the tool. For this tool to be practical as is on EE, I believe the user should be able to store the data and come back and edit at a later time.
|
Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer