|
|
|
| Design and Engineering Forum |
| [Home] [Design Resources] |
| [ POSTING POLICY / RULES ][Archive#1] [Archive #2] [Archive #3] [Calculators] |
|
|
| morse taper1 |  | ||
| Post Reply | Forum | ||
|
Posted by: Madhukar ® 07/27/2004, 07:55:16 Author Profile Mail author Edit |
I'm looking for information on Morse Taper 1 for shank and socket, is there any change required between these in dimensions? This may be for getting better fitment and also disengagement. Madhukar |
| Post Reply | Recommend | Alert | Rate | View All | | | |
| Replies to this message |
| morse taper1 | |||
| Re: morse taper1 -- Madhukar | Post Reply | Top of thread | Forum |
Posted by: RandyKimball ®  07/27/2004, 22:51:02 Author Profile Mail author Edit |
The information you need is provided in the Machinery's Handbook.
Anyone performing a job using a moris taper should purchase one for themselves, (wink). This book is the final statement in most things machine shop wise. Note: this is not an advertisement, I make no money from them, but could not function without the book around my home and work office. -randy- The worst suggestion of you lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them. |
| Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer