|
|
|
| Design and Engineering Forum |
| [Home] [Design Resources] |
| [ POSTING POLICY / RULES ][Archive#1] [Archive #2] [Archive #3] [Calculators] |
|
|
| clearance calculation |  | ||
| Post Reply | Forum | ||
|
Posted by: Lu5ck ® 08/03/2004, 05:32:53 Author Profile Mail author Edit |
i doin a project on clearance on forming, blanking, punching, piercing on stamping process. I a outsider on engineering manufacturing...so i gotta do research abt it and is so confusing and hard to find the forumla for clearance. any kind soul can tell mi the clearance formula for these process? |
| Post Reply | Recommend | Alert | Rate | View All | | Next | |
| Replies to this message |
| Re: clearance calculation |  | ||
| Re: clearance calculation -- Lu5ck | Post Reply | Top of thread | Forum |
Posted by: Cragyon ®  08/04/2004, 08:43:27 Author Profile Mail author Edit |
Clearance between mating parts (if this is what you are reffering to) is typically determined by limits and fit standards. There may be a formula however, I am not aware of any. Check out the following link /tolerance_chart.htm . |
| Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread | | | |
| Re: clearance calculation | |||
| Re: Re: clearance calculation -- Cragyon | Post Reply | Top of thread | Forum |
|
Posted by: Lu5ck ® 08/04/2004, 09:07:45 Author Profile Mail author Edit |
ermm...i mean the clearance...for stamping u nid to hav some space between the hole and the tool rite...if i not wrong |
| Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer