Design and Engineering Forum
[Home] [Design Resources]
[ POSTING POLICY / RULES ][Archive#1] [Archive #2] [Archive #3] [Calculators]

What is FIM limits Smile
Post Reply   Forum
Posted by: eddyhtmok ®

09/10/2004, 05:09:05

Author Profile Mail author Edit

Hello to all experts,

I am now constructing the inspection plan of Hex Jam nut, do any gentlemen/ladies know

what is FIM limit (Runout of Bearing Face, FIM)?

rgds,

Eddy







Post Reply | Recommend | Alert Rate View All   | Next |

Replies to this message


Re: What is FIM limits
Re: What is FIM limits -- eddyhtmok Post Reply Top of thread Forum
Posted by: traingdt ®

09/15/2004, 13:20:45

Author Profile Mail author Edit
FIM stands for Full Indicator Movement, and it is essentially the same thing as Total Indicator Reading (TIR), which some people may already be familiar with.
This means that as the part is rotated, a dial indicator can be held against the surface, and the total deviation (which includes both the plus and minus deviation) cannot exceed the given number.
One caution: to rotate the part in this inspection, it should be clear as to what axis we are rotating around (the "datum," in technical terms). On many parts, different diameters may be designed to share a common axis, but any offset between these could significantly change the FIM readings. (This is why GD&T is recommended; in GD&T we could use the symbols for runout and clearly identify the datum).
Hope that helps...






Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer