Replies to this message

Re: gear backlash
Re: gear -- snapper	Post Reply	Top of thread	Forum

Posted by: mikebull ® 10/05/2004, 07:43:11 Author Profile Mail author Edit

Backlash is to allow the teeth to pass without foul due to temperature expansion and manufacturing errors between teeth. The more accurate the teeth, the less BL is needed. There are rules of thumb e.g (.03 x Mn)+.05mm. The higher the speed then the less backlash the better, but you also need better accuracy with speed. Look in a few textbooks to see the offerings see ( select "email author" for web address of site) some gear calcs Modified by Administrator at Tue, Oct 05, 2004, 08:48:07

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread