Replies to this message

Re:
Re: Original -- Post Reply Top of thread Forum
Posted by: sbasu ®

12/27/2006, 12:00:02

Author Profile
eMail author
Edit

The taper contact used for torque transmission without key in a number of components. Usually the contacts are hydraulically loaded to attain the required contact pressure.
In this regard can any one tell what will be effect of poor initial contact on tapers (say 30 to 40% contact)? though the depth of non contact area is approx 50 microns whereas hydraulic expansion of joint is about 200 microns?







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer