|
FEA using Pro-E | |||
Post Reply | Forum |
Posted by: manulal ® 12/28/2004, 02:22:17 Author Profile eMail author Edit |
Hi, Is FEA & animation possible in Pro-E ? Is Pro-E 2001 package sufficient enough for these two? Manu.
|
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | Next | |
Replies to this message |
Re: FEA using Pro-E | |||
Re: FEA using Pro-E -- manulal | Post Reply | Top of thread | Forum |
Posted by: Cragyon ® 12/29/2004, 18:40:42 Author Profile eMail author Edit |
Check out the pro-e website. There should be a capabilities and add-on packages definitions and apcifications available. |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
Re: Re: FEA using Pro-E | |||
Re: Re: FEA using Pro-E -- Cragyon | Post Reply | Top of thread | Forum |
Posted by: Yin ® 04/17/2007, 03:45:38 Author Profile eMail author Edit |
why you do not use Ansys ------------------------ part-time for ever |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread |
Re: FEA using Pro-E | |||
Re: FEA using Pro-E -- manulal | Post Reply | Top of thread | Forum |
Posted by: kostakis ® 12/29/2004, 06:12:12 Author Profile eMail author Edit |
Of course you can do FEA in Pro/e. You can draw a part and then you can do simulation. |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer