Mechanical Design, Manufacturing and Engineering Forum
[ Home ] [ Search ] [ Engineering and Design Database ] [ Product and Services Directory ]
[ Engineering Forum ] [ DFM DFA Training and Trainers ] [ GD&T Training GD&T Trainers ] [ Advertise ]
[ Archive#1 ] [ Archive #2 ] [ Archive #3] [ Calculators ]
Forum Moderators: randykimball, Administrator

Machining Face Surfaces -- Question
Post Reply   Forum
Posted by: Angi ®

04/04/2005, 16:25:27

Author Profile Mail author Edit
Question -- I have a spec requiring machined surface finish of 3.2um max on one item; and 12.5um max on another. Can someone please tell me how this converts to uin? Normally we just state '125rms' or '500rms' surface machining.

Thanks,
Angi







Post Reply | Recommend | Alert View All   | Next |

Replies to this message


Re: Machining Face Surfaces -- Smile
Re: Machining Face Surfaces -- -- Angi Post Reply Top of thread Forum
Posted by: bjhughes ®

04/05/2005, 12:05:28

Author Profile Mail author Edit
Angi,

1 um = 1/40 uin

Therefore, 3.12 um = 125 uin, and 12.5 um = 500 uin.

Hope this helps.







Post Reply | Recommend | Alert Where am I? Original Top of thread | |
Re: Machining Face Surfaces -- Question
Re: Re: Machining Face Surfaces -- -- bjhughes Post Reply Top of thread Forum
Posted by: Angi ®

04/05/2005, 12:20:37

Author Profile Mail author Edit
Thank you for your reply. It was very helpful.

Can you also please tell me the definition of 'uin' and 'um'. I'm assuming uin is units in inches or something like that and um refers to metric units. I am trying to pass along this knowledge to my production department and don't want to stear them the wrong direction.

Again, thanks so very much for your help.







Post Reply | Recommend | Alert Where am I? Original Top of thread
Re: Machining Face Surfaces -- Question
Re: Re: Machining Face Surfaces -- -- bjhughes Post Reply Top of thread Forum
Posted by: Angi ®

04/05/2005, 12:20:14

Author Profile Mail author Edit
Thank you for your reply. It was very helpful.

Can you also please tell me the definition of 'uin' and 'um'. I'm assuming uin is units in inches or something like that and um refers to metric units. I am trying to pass along this knowledge to my production department and don't want to stear them the wrong direction.

Again, thanks so very much for your help.







Post Reply | Recommend | Alert Where am I? Original Top of thread | |
Re: Machining Face Surfaces -- Smile
Re: Re: Machining Face Surfaces -- -- Angi Post Reply Top of thread Forum
Posted by: bjhughes ®

04/05/2005, 12:55:10

Author Profile Mail author Edit
Angi,

um = micro-meters (10E-6)

uin = micro-inches (10E-6)

The "u" should actually be the greek letter "mew", which is standard engineering symbol for "micro" (10E-6).

Good luck. Take Care.







Post Reply | Recommend | Alert Where am I? Original Top of thread | |
Re: Machining Face Surfaces -- Smile
Re: Re: Machining Face Surfaces -- -- bjhughes Post Reply Top of thread Forum
Posted by: Angi ®

04/05/2005, 13:44:12

Author Profile Mail author Edit
Thank you! You have been very helpful.

Angi







Post Reply | Recommend | Alert Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer