Need help figuring out torque value. Question
Post Reply   Forum
Posted by: enespear ®

10/12/2005, 11:05:49

Author Profile Mail author Edit
I have a block with 10-32 threads, the block is made of t6061 t6 the threads and block are black hard coated. I am screwing a grade 8 steel black oxided screw into to it. How can i figure out the Torque value for the aluminum threads.






Post Reply | Recommend | Alert View All   | |

Replies to this message


Re: Need help figuring out torque value.
Re: Need help figuring out torque value. -- enespear Post Reply Top of thread Forum
Posted by: kelly_bramble ® Administrator, Administrator

10/12/2005, 12:28:44

Author Profile Mail author Edit
Check out the following webpage, everything you need is there:

/fastener_thread_menu.shtml

In general, you need to figure out how much force you need/allowed then compare the resultant stress to the fastner and the threaded part.

The grade eight bolt is much more rugged than the aluminum, so you will actualy be designing for the aluminum part stresses.







Post Reply | Recommend | Alert Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer