Replies to this message

Re: sheet metal-BURRING
Re: sheet metal-BURRING -- anandphadnis	Post Reply	Top of thread	Forum

Posted by: rowzee ® 10/19/2005, 11:28:10 Author Profile Mail author Edit

Can you please clarify, is this in regards to burrs created after a blank, trim or pierce operation?

Post Reply | Recommend | Alert

Where am I? Original Top of thread

| |

Re: sheet metal-BURRING
Re: Re: sheet metal-BURRING -- rowzee	Post Reply	Top of thread	Forum

Posted by: KCC ® 11/14/2005, 13:46:23 Author Profile Mail author Edit

I can't speak for what is being asked but are there any engineering standards for sheet metal burr allowance? This may help out the original question and will help me out at the same time. I have called a few sheet metal houses that have their own standards so I'm curious if there are any written standards that should be used.

Post Reply | Recommend | Alert

Where am I? Original Top of thread