Replies to this message

Re: make this ortho to isometric view
Re: make this ortho to isometric view -- stanly	Post Reply	Top of thread	Forum

Posted by: Adilogic ® 12/07/2005, 18:01:43 Author Profile Mail author Edit

Right view is a deformed circle, such that the "trajectory" passes from one quadrant to the other normal to the quadrant axis that it passes. The section tends to get squared. The pic will explain better. I have to see if I can attach it. Adi Modified by Adilogic at Wed, Dec 07, 2005, 18:02:46

Post Reply | Recommend | Alert

Where am I? Original Top of thread

Re: make this ortho to isometric view
Re: make this ortho to isometric view -- stanly	Post Reply	Top of thread	Forum

Posted by: ashok_k ® 11/30/2005, 01:58:11 Author Profile Mail author Edit

I THINK THIS IS CYLINDER TO BE CUT FROM BASE AT 45 DEG. ANGLE (OUTERMOST POINT),

Post Reply | Recommend | Alert

Where am I? Original Top of thread

| |

Re: make this ortho to isometric view
Re: Re: make this ortho to isometric view -- ashok_k	Post Reply	Top of thread	Forum

Posted by: stanly ® 12/03/2005, 03:17:24 Author Profile Mail author Edit

thanks for reply its not a cylinder i had checked that one also

Post Reply | Recommend | Alert

Where am I? Original Top of thread

| |

Re: make this ortho to isometric view
Re: Re: make this ortho to isometric view -- stanly	Post Reply	Top of thread	Forum

Posted by: stanly ® 12/19/2005, 10:48:54 Author Profile Mail author Edit

thanks for ur answer

Post Reply | Recommend | Alert

Where am I? Original Top of thread

Re: make this ortho to isometric view
Re: Re: make this ortho to isometric view -- stanly	Post Reply	Top of thread	Forum

Posted by: jeffborowski ® 12/15/2005, 14:01:15 Author Profile Mail author Edit

Picture a cylinder. From the top it is a circle, from the front it is a square and from the side it is a square. Now take that cylinder in the front view and grind it round. You now have a circle in the top view, a circle in the front view and a square in the side view. The isometric view will have an outline like a diamond. If the pic does not show up just cut and past the link. Jeff [img]https://www.helifreak.com/album_showpage.php?pic_id=6396[/img]

Post Reply | Recommend | Alert

Where am I? Original Top of thread

| |

Re: make this ortho to isometric view
Re: Re: make this ortho to isometric view -- jeffborowski	Post Reply	Top of thread	Forum

Posted by: Adilogic ® 12/19/2005, 12:06:36 Author Profile Mail author Edit

I see, I was trying to follow the definition of "view" as in drawings, where you have to draw the edges that you see from that view. In your solution the top/front view is a circle with a line along the vertical diagonal:(|) It would have been more correct to say front/top "section view". That was the catch. Missed it.

Post Reply | Recommend | Alert

Where am I? Original Top of thread