|
Shaft through metal under water | |||
Post Reply | Forum |
Posted by: fzn10 ® 05/07/2006, 06:59:44 Author Profile eMail author Edit |
Hi im an electrical engineering student, dont know much about mechanical. I want to built a small under water turbine, I need a water proof casing and currently the problem is having the shaft to go in to the metal casing without letting water and sand in, iv googled it, cant seem to get what i want. does any one have any good resources on how to do this. Thanx |
Post Reply | Recommend Email | Alert Administrator | View All | | | |
Replies to this message |
Re: Shaft through metal under water | |||
Re: Shaft through metal under water -- fzn10 | Post Reply | Top of thread | Forum |
Posted by: randykimball ® 05/07/2006, 10:02:50 Author Profile eMail author Edit |
How deep are you going to be going under water? You need a gland for the shaft to pass through. The shaft needs to run true and not wobble in the gland. The gland needs to have a seal pressed into it which fits the shaft diameter and points the right direction to hold out water. (This similar to the seal that is used in places like the rear of your transmission of your auto to keep in transmission fluid). The gland needs to be water tight to the housing. I prefer to have two seals a short distance apart and place a lubrication between them during installation when using seals under water as water has very little lubrication quality. This keeps the seals "alive" longer. If you are going to extreme depths you may need more seals and or a packing gland. Extreme depths would be thousands of feet. The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them. Modified by randykimball at Sun, May 07, 2006, 10:09:13 |
Post Reply | Recommend Email | Alert Administrator | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer