|
bending beams | |||
Post Reply | Forum |
Posted by: catbrandt ® 06/22/2006, 09:50:40 Author Profile eMail author Edit |
I am trying to build a shelf out of angle iron that will hold a total weight of 661.5lbs. The three supports are spaced at follows, 23.75" from left end, then 84.5" to next support, then 121.5" to next support, then 22.25" to other end. I have shown a drawing of how the supports look. It is a bad drawing but it is the only way I could figure out how to post it. Any help would be greatly appreciated.
|
Post Reply | Tell a Friend (must be logged in) | Alert Admin About Post | View All | | | |
Replies to this message |
Re: bending beams | |||
Re: bending beams -- catbrandt | Post Reply | Top of thread | Forum |
Posted by: Scooter ® 06/22/2006, 12:26:23 Author Profile eMail author Edit |
You show an end view. It's ok, could you show a Front View & add dimentions. Also, a "Birds eye" view would help. With this I think some one can help you with this design. Thanks, Scooter |
Post Reply | Tell a Friend (must be logged in) | Alert Admin About Post | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer