plastic-material type recommended
Post Reply   Forum
Posted by: cpalka ®

08/25/2006, 15:07:00

Author Profile
eMail author
Edit

Hi,

Can you please advise what type of plastic is recommended to use for HVAC unit casing/enclosure.
Plastic type will be exposed to temp. from -40deg.F to 211deg.F and grease (located in engine compartment).

Thks,
Cezar








Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
View All   | Next |

Replies to this message

Re: plastic-material type recommended
Re: plastic-material type recommended -- cpalka Post Reply Top of thread Forum
Posted by: k_rg ®
Tweety Bird
12/06/2006, 23:02:14

Author Profile
eMail author
Edit

Many choices are available. You may use PBT like Arnite* made by DSM which is a high-performance engineering plastic that combine high strength and rigidity. .




R.Gopal


Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer