Engineers Edge

[Home] [Design Resources] [Technology Store]

Re: Special Screw
Re: Special Screw -- Domenick Post Reply Top of thread Forum
Posted by: randy.kimballRandy Kimball

11/09/2002, 10:23:32

Edit
Domenick,Not being a microwave wise engineer I still think I havea simple answer worth trying in an experiment. Ithink you need to plug the space between thethread roots with a metalic substance, if I'm right.So, I would look for a metalic thread sealant orat least one that is not passive to your frequencyof wave length. Thus blocking the leakage. ... or perhaps I have caused you the think of asimilar route to take. I agree, a better class of thread fit will help but can make the screws to expensive.I'd contact some of the thread sealant/glue makersabout a product or a new product for this purpose.I have found them responsive and always looking fornew examples of ways to sell new sealant/glue products... good luck..








Post Reply | Recommend | Alert Rate Where am I? Original Top of thread | Next |

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer