Housing tolerances

Housing tolerances
	Post Reply		Forum

Posted by: sbasu ^®

01/03/2007, 11:38:31

Can anybody give the requirements for the Fit for a thin shell housing in which a bevel shaft is fitted with two sph roller bearings. The Housing is slided in a Rigid gear box bore and tightened with bolts. The bevel contact load is thus like a cantilever.
What should be the Gear Box bore and the Housing OD fit ?
What will be the effect if the clearance is increased say by a factor 25% ?

Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post