CrankCase Door Studs failure Question
Post Reply   Forum
Posted by: matin ®

01/10/2007, 10:52:42

Author Profile
eMail author
Edit

We have in our facility Wartsila SW 18V 38 series engines rated at 11.3 MW.The crankcase pressure is 2mmH2O as company OEM standards still the crankcase door holding studs are breaking very frequently there is no excessive vibration no excessive crankcase pressure.

No explanation has been identified to this behaviour?????????

CC door stands on 04 studs.If we replace the stud with much stronger material then there is a chance that CC door will actually break apart that is what we assume but not has been tried.








Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
View All   | Next |

Replies to this message

Re: CrankCase Door Studs failure
Re: CrankCase Door Studs failure -- matin Post Reply Top of thread Forum
Posted by: tassos.arvanitis ®

01/11/2007, 11:59:51

Author Profile
eMail author
Edit

Dear Friend,
I believe that tightenning torque and rapid temperatue changes affect the studs. Check tightenning torque and monitor the temperatures on the doors.







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer