|
set up angle | |||
Post Reply | Forum |
Posted by: vishukvr ® 04/09/2007, 00:04:39 Author Profile eMail author Edit |
hi,
what is set up angle in press tool components??????????for example a component set up Angleis 7.5deg in X - direction??????????????????????????????????? |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | | |
Replies to this message |
Re: set up angle | |||
Re: set up angle -- vishukvr | Post Reply | Top of thread | Forum |
Posted by: randykimball ® 04/09/2007, 16:26:15 Author Profile eMail author Edit |
Most likely (hard to tell from the small amount of data provided) they are describing a 7.5° break up from the plane of the remainder of the stock while the sheet is laying on x axis (a table top). The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them. |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer