|
Concentricity | |||
Post Reply | Forum |
Posted by: off center ® 06/25/2007, 14:51:39 Author Profile eMail author Edit |
My quistion is about implyed tolerance. If there is no concentricity call out how is it implyed? |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | | |
Replies to this message |
Re: Concentricity | |||
Re: Concentricity -- off center | Post Reply | Top of thread | Forum |
Posted by: randykimball ® 06/25/2007, 15:48:46 Author Profile eMail author Edit |
Within the tolerances specified in the tolerance block of the print. The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them. |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer