[Home] [Design Resources] [Technology Store]
[Archive#1] [Archive #2] [Archive #3] [Calculators]
Forming 4 inch thk alum plate...
Post Reply   Forum
Posted by: pmaru77 ®

05/15/2003, 18:16:38
Author Profile Mail author Edit
I have a part that requires bending 4inch thk alum plate with approx 4 inch inside raduis. Forging is the likely possibility...but was hoping to not have to go that route. Anyone with a LARGE press in the L.A. area?






Post Reply | Recommend | Alert Rate   Previous |   |

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer