|
||||||||||||
|
||||||||||||
| calc bolt thread strength | |||
| Post Reply | Engineering Forum | ||
| Posted by: Bennie ® 06/15/2009, 06:43:51 Author Profile eMail author Edit |
I want to calc which thread is the strongest under a compression load, 1 ½" x6 TPI BSW (OD38.1mm & ID 32.7mm) or M40x2 pitch (OD40mm & ID37.402mm). Both bolts are manufacture from stainless steel 304.
According to my calc the 1 ½" BSW have the shortest engagement length of the two. |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | Next | |
| Replies to this message |
| : calc bolt thread strength | |||
| : calc bolt thread strength -- Bennie | Post Reply | Top of thread | Engineering Forum |
| Posted by: Kelly Bramble ® 06/20/2009, 17:25:14 Author Profile eMail author Edit |
Also see /fastener_thread_menu.shtml
|
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
| : calc bolt thread strength | |||
| : calc bolt thread strength -- Bennie | Post Reply | Top of thread | Engineering Forum |
| Posted by: Pooch ® 06/16/2009, 07:55:38 Author Profile eMail author Edit |
Bennie
Calculate the cross section of the thread at the pitch line, times the length of the pitch circle. Pi x D x cross section. Boggs is correct, Machinery's Handbook will be very helpful on this. |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
| : calc bolt thread strength | |||
| : calc bolt thread strength -- Bennie | Post Reply | Top of thread | Engineering Forum |
| Posted by: jboggs ® 06/15/2009, 18:12:51 Author Profile eMail author Edit |
Machinery's Handbook has some great thread strength formulas. |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
