|
BEND LINES | |||
Post Reply | Engineering Forum |
Posted by: DOMINIC ® 10/29/2009, 10:57:53 Author Profile eMail author Edit |
Hello, How do you indicate bend lines on a drawing for sheet metal?
Thanks in advance Modified by DOMINIC at Fri, Oct 30, 2009, 14:36:04 |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | Next | |
Replies to this message |
: BEND LINES | |||
: BEND LINES -- DOMINIC | Post Reply | Top of thread | Engineering Forum |
Posted by: AVIB ® 11/03/2009, 12:01:19 Author Profile eMail author Edit |
Hi ,
Let me ask you this : why you need this ? If you make a drawing of the final product then why mark bend lines ? AVIB |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
: BEND LINES | |||
: BEND LINES -- DOMINIC | Post Reply | Top of thread | Engineering Forum |
Posted by: SIVA_KOVAI ® 11/03/2009, 07:00:50 Author Profile eMail author Edit |
You can show by dotted lines. SIVA |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer