|
Use of lockwashers in plastic assemblies | |||
Post Reply | Forum |
Posted by: abchow ® 02/13/2006, 15:52:45 Author Profile eMail author Edit |
I am reviewing a number of assemblies where the engineer called out the use of lockwashers when assembling hard plastic parts to aluminum parts. The washers are used in all sizes from #2 to #8 cap screws. My opinion is that lockwashers are non-functional in this application since the plastic part provides more than enough compression to maintain screw preload. Anyone share their thoughts? |
Post Reply | Recommend | Alert Administrator | View All | | | |
Replies to this message |
Re: Use of lockwashers in plastic assemblies | |||
Re: Use of lockwashers in plastic assemblies -- abchow | Post Reply | Top of thread | Forum |
Posted by: Kelly_Bramble ® 02/13/2006, 16:21:40 Author Profile eMail author Edit |
Many, if not most polymers (plastics) tend to creep (elongate, stretch or compress)with the application of stress (load). Cyclic loading, and thermal variations tend to accelerate the polymers deformation over time. Depending on your application, the lock washer could be a very good (quality) ideal.
|
Post Reply | Recommend | Alert Administrator | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer