|
Design triangle frame for bracket. | |||
Post Reply | Forum |
Posted by: hawadila ® 05/19/2006, 05:17:57 Author Profile eMail author Edit |
Hi..
I need to design a triangle frame for bracketing. This bracket will use to hold a pipe with certain diameter and length. The purpose of this task is to find a max load that can be hold by the bracket. So i need to work backwards to solve this problem. Can anyone pls give advise on how to solve this problem?At now i currently stuck and dont know were to start this task. Thanks. |
Post Reply | Recommend Email | Alert Administrator | View All | | | |
Replies to this message |
Re: Design triangle frame for bracket. | |||
Re: Design triangle frame for bracket. -- hawadila | Post Reply | Top of thread | Forum |
Posted by: zekeman ® 05/19/2006, 17:17:49 Author Profile eMail author Edit |
Looks like a HW problem. If not, then you have to figure out how to resolve forces in the triangular section--basic statics.
Just sketch the system and assume pin connected bracket for openers. |
Post Reply | Recommend Email | Alert Administrator | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer