Engineers Edge

[Home] [Design Resources] [Technology Store]

True position tolerance zone
Post Reply   Forum
Posted by: Andy

11/13/2002, 04:52:50

Edit
How do you apply a true position tolerance to a hole without a diameter symbol preceeding the tolerance value?I assume its two parallel planes along each axis. Is this correct?Can someone point me to any online sites that explain this.Thanks in advanceAndy








Post Reply | Recommend | Alert Rate View All   | Next |

Replies to this message

-----Re: True position tolerance zone Jacek Palinski 0 907 bytes 11/14/2002, 14:20:22
-----Re: True position tolerance zone Randy Kimball 0 661 bytes 11/16/2002, 11:17:05
-----Re: True position tolerance zone John-Paul Belanger 0 479 bytes 11/22/2002, 22:57:05

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer