Pulley Design Help Question
Post Reply   Forum
Posted by: cdchick1 ®

01/05/2007, 14:34:54

Author Profile
eMail author
Edit

I need to design a pulley system to drop a mass at 45 mph in 30 feet or less. How do I design the pulley system and how do I show this mathematically? Any help would be great. Thx







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
View All   | |

Replies to this message

Re: Pulley Design Help
Re: Pulley Design Help -- cdchick1 Post Reply Top of thread Forum
Posted by: randykimball ®
Barney
01/05/2007, 19:42:13

Author Profile
eMail author
Edit

For starters if you want that kind of accel you most likely want a pulley above AND below to maintain tention over the pulley runs. Then you can pull the load up or down.




The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.


Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer