levers problem
	Post Reply		Forum

Posted by: laufer ® 02/13/2007, 09:26:20 Author Profile eMail author Edit

I need, to if some one can tell me a simple software witch is able to calculate the example on the Picture, I must change the levers because a need more force without change the cilinder diameter

Replies to this message

Re: levers problem
Re: levers problem -- laufer	Post Reply	Top of thread	Forum

Posted by: randykimball ® 02/13/2007, 20:40:49 Author Profile eMail author Edit

Plug your calculations into MS Excel. Going down the sheet vary the length in control groups. This way you have a listed result sheet that can be plotted, and which will show you what to expect as the pattern takes shape. Do a good job on the sheet and save it to use again.. I have a special folder on my systems full of them. The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.

Post Reply Tell a Friend (must be logged in) Alert Admin About Post

Where am I? Original Top of thread

Re: levers problem
Re: levers problem -- laufer	Post Reply	Top of thread	Forum

Posted by: Marky ® 02/13/2007, 16:09:35 Author Profile eMail author Edit

Solidworks may help

Post Reply Tell a Friend (must be logged in) Alert Admin About Post

Where am I? Original Top of thread

| |